Intended Application:   Ninco home or club sets, through mildly modified 1/32 motors

Polarity:   negative

Ending/Plugs:   6.4mm plug

Recommended Operating Voltage:   stock wall-plug power packs

Features:

     - "Platinum Series" transistor-based technology

     - internal handle-protected aluminum heat sink

     - 6.4mm plug on a 6-foot, heavy-duty 16 gauge lead

     - high quality molded wire cord with integral strain relief

     - high-impact polycarbonate plastic molded handle

     - stainless steel hardware throughout

     - low friction silver alloy wiper button with ultra-hard nickel-plated contact surface

Professor Motor handle color options:  black, clear, red, blue, orange, yellow-green

Not all colors are available at all times. You can leave color preferences in the Comment section of your order or contact customer service.

Operating Note:   this controller will work with the Ninco 10416 power base BUT only with the direction switch in ONE of its two positions -- when you flip the switch it changes the polarity that the controller sees. Another option is to simply reverse the two wires coming from the power supply - that also will change the polarity as the controller sees it.

Care & Maintenance:

Regular maintenance is required to keep the controller contacts clean and free from foreign objects & debris. Failure to properly clean, lube and maintain the contacts will cause the controller to fail, will allow the car to be driven without the throttle being depressed and can result in short circuits & damage. The trigger pivot bushing should also be lubed periodically with plastic-compatible oil.