Special Limited Edition Difalco 1/32 Controller Set by Electric Dreams.
SHIPS MID-AUGUST
This set comes with a fully loaded DD304 Genesis HD30 controller:
- controller with black handle and black electronic board;
- 3 potentiometers: Brake, Sensitivity, and Traction Control;
- anodized knobs made by IndYcator - square brake knob for easy identification while racing
- 3 sensitivity network options included: 290 ohm (DD262), 377 ohm (DD282), and 218 ohm (DD263);
- single and double-finger triggers (installed);
- exclusive custom hand-made leather case by Schroeder Craftworks;
- limited edition of 10 pieces ONLY;
- digital voltmeter;
- controller hand-built by legendary Jim Difalco
Genesis HD30 controllers feature a thin multi-conductor cable with innovative ESP (Extreme Stopping Power) brake relay:
- located on the heatsink/transistor assembly just 1’ from the hook-up studs for reduced brake circuit resistance
- activated by a tiny slide switch on the main circuit board and bypasses both the brake rheostat and the brake fuse for the lowest resistance possible
- has diode protection to prevent it from turning on in case of incorrect hook up
- activated by the wiper board even before the trigger reaches the normal brake post, turning on the relay earlier for better braking response
- a full power relay with flexible 12 gauge wire to get all the power to the track
Genesis controllers also feature an exclusive plug-in network circuit board that changes the band response to tune the controller to best match your motors R.P.M. and driving style!
This 30 band controller designed for 1/32 type cars has the Genesis cable design with a super small heatsink. E.S.P. brake relay for excellent full brakes. 25 ohm brake rheostat. Comes standard with a 290 ohm network that controls most 1/32 motors. Optional networks available. Copper alligator clips. Positive polarity only.
This model comes with the traction control feature - adjustable rheostat shifts the sensitivity range and reduces the power on the last band of the controller, limiting the power available to reduce the chance of overpowering the car and sliding out at the end of a turn.
About the leather case from Schroeder Craftworks:
Made of 5oz black chrome-tan weather-resistant leather with a brass zipper #5 and embedded Electric Dreams logo. The yellow stitching #5 thread from Vinymo MBT is a unique, bonded, non-lubricated thread where the strands are tightly wound and internally bonded, making it incredibly strong. The stitching is done by machine, providing a solid lock stitch, while everything else is hand-made.









